Upgrade Software

IMPORTANT: BEFORE DOWNLOADING PGM-01 SOFTWARE, CLICK HERE.

USB Programmer Driver for PGM-01
Download this first to install your PGM-01 USB Programmer.

USB Programmer Driver For PGM-V2
Download this first to install your PGM-V2 USB Programmer.

UPGRADES FOR TP-1010C:

TP1010C Programmer Instructions
Instructions to help you setup your TP1010C Programmer.

 

TP1010C V2.00D Upgrade For PGM-01:
Charge mode for A123 data:
Topoff charge:3.65V
Over voltage error:3.85V
Initaial slow charge to 3.0V
A123 recovory mode: 1.5V

--Discharge voltage minimum 3.0V
How to select A123:
Go to Option->charge setting mode
Press INC key until the LCD displays A123cell charge
mode.

TP1010C V2.1A Upgrade for PGM-01
Charge mode for A123 data:
Topoff Charge: 3.65V
Over voltage error:3.85V
Initaial slow charge to 2.4V
A123 recovory mode: 1.5V
Li-Po Recovery mode: 2.0V

TP1010C V2.5 UPGRADE FOR PGM-V2
TP1010C V2.5 UPGRADE FOR PGM-01

  • Added NiCd/NiMh/PB (SLA)/LiFe (A123) battery charge/discharge/cycle functions
  • Up to 10 memory slots are independently assignable for each chemistry type
  • LiFe (A123) top off voltage is adjusted to 3.65V/cell
  • Added selectable 2-10 hour system timeout function
  • The last cycle data of charge and discharge before an error interruption occurs can be viewed by pressing the [Sel] (Select) button.
  • Discharge power factor added
  • Added 1's decimal digit to the voltage display
  • At boot up, the screen message now shows "Thunder Power RC" (used to show "Thunder Power")
  • Recovery mode:
    Increased from C/4 to C/2
    Increased from 60 minutes to 120 minutes
  • All nomenclature that said "A123" now says "LiFe"
  • NiMH and NiCd Delta Peak algorithms have been optimized to reduce/prevent issues of false peaking
  • Improved error warning information

UPGRADES FOR TP-610:

TP610C V5.5 UPGRADE FOR PGM-V2
TP610C V5.5 UPGRADE FOR PGM-01

  • All nomenclature that said "A123" now says "LiFe"
  • Minimum charge current changed to 0.1A.
  • NiMH/NiCd Delta V rose to 15mV for NiMH and 30mV for NiCd, less false peaking.

 

*Any questions or concerns please contact customer service 702-228-8883*